Depend Remover Oil
Warning: Last items in stock!
2. Massage over each nail for about 20-30 seconds.
3. Pour the water into the bowl or washbasin. The temperature should be about 40°C. NB: Do not scald your fingers.
4. Lower your fingers into the hot water (about 40°C) so that all the fingers are covered by the water. Wait 3 minutes. The hotter the water the better the effect.
5. After about 3 minutes, begin to gently scrape the gel away from the area of new growth near the cuticle, using your own fingernail or an orange stick. Keep your hand in the water as you do this. Scrape a little and allow the water to reach the join between the GelLack and your nail. This will gradually loosen the GelLack, enabling you to peel it off in one piece if you follow the instructions correctly. It is the reaction between the oil, the
GelLack formula and the water that makes this unique removal method possible.
Important – remember that the water will cool, and for best results the temperature must be about 40 degrees. It may be a good idea to replace the water or heat it during the removal process. 6. If you can’t get all of the polish off your nails, repeat with more oil and hot water, following the instructions above, until the polish comes off completely. Repeat the same procedure for the other hand. Finish off by massaging in any excess oil and wipe your hands dry.