USB Electric Nose Hair Trimmer

Remove the protective cap from the trimmer head. Press the power button to turn on the device.Gently bring the trimmer head close to the entrance of the nostril or ear canal.Carefully insert the head a few millimeters and let the device trim the hair.Once finished, turn off the device by pressing the power button again. Clean the trimmer head following the instructions in the Cleaning and Maintenance section.Replace the protective cap when the trimmer head is clean and dry. Note: It is normal for the trimmer head to become slightly warm during use due to friction. Cleaning and MaintenanceAlways turn off the device before cleaning it.Do not wash the device or the trimmer head under running water. Use the included cleaning brush to remove any remaining hair.Power and Charging InstructionsThis product operates on a built-in rechargeable lithium-polymer battery. Use a suitable adapter (or a computer's USB port) and a USB-C charging cable to charge it. Using the original cable is recommended. • Do not use near bathtubs, sinks, or other water sources. The device is not waterproof: do not wash or submerge it. If used in the bathroom, unplug it afterward, even if it is switched off. Do not leave it plugged in unattended. • Contains a 150 mAh lithium battery. Do not expose to direct heat or strong electromagnetic fields. Do not drop, strike, or tamper with the device. Do not disassemble or attempt to repair it yourself. • When it is time to dispose of the product, please consider the environmental impact and take it to a suitable recycling point. The plastics and metals used in this device can be separated for recycling. Ask at your nearest recycling center for details. Batteries and accumulators should never be disposed of with other household waste. If you wish to dispose of the battery or accumulator, please place it in the designated containers at the point of sale or at your nearest municipal waste collection center or recycling facility. CAUTION: Do not use this device near bathtubs, showers, sinks, or other containers holding water. You can apply a drop of lubricant to the head after cleaning to maintain optimal performance.Make sure the head is clean and dry before replacing the protective cap. Safety Warnings- This product is intended for personal use only. - Do not use the hair clipper on wounds, irritations, or skin infections. - Do not insert the head into the ear canal or too far into the nostrils. - Keep the device out of the reach of children. - Do not use the device while it is charging. - If the device shows damage to the head, battery, or body, stop using it.This device should only be powered by the corresponding extra-low safety voltage marked on the device. Use only cables and chargers compatible with a USB Type-C port. Do not pull, bend, or coil the cable; always disconnect by pulling on the plug. If the cable is damaged or overheats, stop using it. Do not use near bathtubs, sinks, or other water sources. The device is not waterproof: do not wash or submerge it. If used in the bathroom, unplug after use, as proximity to water poses a hazard even when the device is switched off. Do not leave it plugged in unattended. Keep the device dry. [The device is not waterproof:]