T&T Manicure - Pedicure

Step by step GelLack permanent manicure

On: 29 / 10 / 2015 Comment: 0
Step by step GelLack permanent manicure. The polishing process with GelLack is a ritual that always begins with the four fingers of one hand, from the little finger to the index. So, follow all the steps listed below on these four fingers.

1. Before starting

Before you start, pay attention to the new application and cleaning technique: it is very important to clean the slightly sticky surface that remains on the nail every time GelLack Top, Base or Colour hardens under the LED lamp. Soak a cotton pad with Depend Before and After Cleanser and press onto the nail and leave it on for 5 seconds, wipe it off the entire length of the nail, do not rub horizontally. You must do this on all nails each time after hardening under the LED lamp. Use a new cotton pad after cleansing 4 fingers.


PASO-01.jpg

Step 1

Apply Depend Before and After Cleanser with a cotton pad and carefully clean your nails. Let them dry for about 30 seconds. Do not touch the surface of the nail after cleaning. You must not use GelLack in the following cases: - If you are allergic to acrylates, as these products can cause an allergic reaction. The risk may occur when the skin comes into contact with the liquid products GelLack Base, Top and / or Colour before hardening (before nails are placed under the LED lamp). - If you have previously had an allergic reaction to any similar product. - If you bite your nails or have very short nails, because it is difficult to apply the product if your nail is shorter than the skin of the fingertip. - If your cuticles are broken or damaged or if you have nails in poor condition (thin, dry or split). - If you are under sixteen.

PASO-01.jpg

Step 2

Apply a thin layer of Depend GelLack BASE / Step 2 without touching the cuticle or skin. Now, clean the nails with a cotton pad soaked in Depend Before and After Cleanser, without rubbing horizontally. Wait 20 seconds before moving to the next step. Important: In all the steps, if GelLack comes into contact with skin, you should remove it before it hardens with some Depend Before and After Cleanser on a cotton bud or Beter Manicure Express nail polish corrector.

PASO-02.jpg

Step 3

Now, apply a thin layer of Depend GelLack Colour permanent coloured nail polish without touching the cuticle or the skin around the nail. Let it dry another 30 seconds under the LED lamp. Clean the nails with a cotton pad soaked with Depend Before and After Cleanser, without rubbing horizontally. Repeat the operation and apply another layer of colour, let it dry again under the LED lamp for 30 seconds around the nail. Let it dry 30 seconds under the LED lamp. Clean the nails again with a cotton pad soaked with Depend Before and after Cleanser. Wait 20 seconds before moving on to the next step.

Step 4

The moment has arrived to apply a layer of Depend GelLack TOP / Step 4. Try not to touch the cuticle or the skin around the nail and let it to dry under the LED lamp for 30 seconds.

PASO-04.jpg

Step 5

On finishing the process, the surface of your nails will be slightly sticky: clean them with a cotton disc soaked with Depend Before and After Cleanser. Do not rub the disc horizontally.

PASO-05.jpg

Step 6

Carry out the same steps on the four fingers of the other hand and then do the thumbnails.

Guardar